SATA card to USB 3

Delivery : 3 days

SATA card to USB 3

Access a 2.5" disk using the Raspberry Pi 4's USB3 port!

The drive should consume less than 1A, ideally an SSD.
Kit compatible with Diskio Pi v1.1/1.2, a USB 2.0 cable is provided to replace the angled cable.
In Stock


Disk compatibility:

2'5 SATA disk, thickness 7mm
Power consumption <1A
SSD recommended

In the box :

  • SATA to USB3 card based on JMicron JMS578 chip (USB 3.0)
  • Disk mounting part
  • Card casing
  • USB2 cable (to replace the angled cable)
  • Fixing screws

Test of reading speeds :

sudo hdparm -tT /dev/sda
 Timing cached reads:   1478 MB in  2.00 seconds = 739.00 MB/sec
 Timing buffered disk reads: 878 MB in  3.00 seconds = 292.44 MB/sec

Mounting :

In order to access the USB 3 port, a new USB 2 cable to the daughterboard's HUB is provided.
The cable from the board connects to the USB3 port on the Raspberry Pi, and fits naturally when the case is closed.

See the Wiki for assembly details.

Questions / Feedback

Be the first to ask a question about this product!

Question about the product

* Required fields