Version 1.2

Closing the housing and mounting the stand

From Wiki Diskio Pi
Jump to navigation Jump to search
This page is a translated version of the page Fermeture du carter et montage du pied and the translation is 96% complete.

Outdated translations are marked like this.
Other languages:
English • ‎français

This tutorial is based on versions 1.0.A and 1.0.B of the kit. A new page will be created for version 1.0.C.

Housing check

Before placing the housing on the terminal, check that the edges are straight. Otherwise, there may be a distortion of the screen, which would cause ghost clicks.

1. Look at the edges of the housing, and check that it is not bent, as in this example:

Courbure carter1.jpg Courbure carter2.jpg

Modification

2.1 If it is bent, it must be straightened. To do this, the ideal is to heat it so that it can be slightly deformed.
I use a hot air blower, but I think that with a hot hair dryer it can do the job. Otherwise, very hot (but not boiling) water: soak the side for a few seconds and bend the side evenly so that it finds a straight line.

2.2 A second approach could be not to tighten the screws on the sides of the housing too much, and/or to place spacers (washers 1 or 2 mm thick) between the hull and the housing, before screwing.
 2.3 However, the results seems better when both solutions are applied.

With this modification, the housing will no longer press in the middle of the edges and the screen will not be deformed. If you have any doubt, come and talk about it on the forum !

Cover closing

 1 The cover is placed open, at an angle of about 80° to the shelf. Place the hinges in the openings provided, then close them gently.

Fermeture carter1.jpg

 2 Check that all the hooks are secured in the hull, then complete the closure by screwing the three screws provided (M2.5x8mm).
Do not overtighten the corner screws, or do not tighten them at all, unless you have made the previous modification.

Fermeture carter2.jpg

stand mounting

For this assembly, use the M2x5mm screws: Vis pied.jpg

 1 Place the sides holding firmly on the edges, then screw in the two screws per side, without overtightening.

Montage pied cote1.jpg Montage pied cote2.jpg

 2 Insert the rounded part until it locks.

Montage pied cape1.jpg Montage pied cape2.jpg

 3 Screw the two screws at the base of the triangles, using the holes in the rounded part. This time, don't hesitate to tighten well.

Montage pied cape3.jpg

 4 Check that the side is inserted in the slot of the rounded part.

Montage pied cape4.jpg

 5 Finally, finish screwing the two screws at the two vertices of the triangles. Here again, do not hesitate to tighten well.

Montage pied cape5.jpg

Finished !

<<back